Why Jaw crusher not meet factory standards of production？
A customer asked why the Jaw Crusher (provision of equipment: Crusher) can not achieve the stated output sometimes can not achieve? In this regard, Shanghai Jianye Heavy Industry Co.,Ltd pointed out that the jaw crusher factory production standards are strict standards, and in many parts of what makes this production has not been the situation, because there are many, such as:
1) The hardness and toughness of materials broken over the extent provided instructions;
2) The location of motor wiring reversed, the host to open anti-vehicle (moving jaw clockwise rotation), or electrical wiring connected to form a triangle star connection;
3) Nesting population less than the specified limit;
4) Jaw plates shift, the relative tooth top and addendum;
5) Low voltage work site;
6) Movable jaw and the space, excessive bearing wear, so that there is relative bearing outer ring rotation.
Crusher in understand why standards fail to yield problems, the next solution is simple and clear.
Remedy:
1) The replacement or increase crusher;
2) Exchange motor wiring;
3) Nesting I adjusted to the nominal specification requirements and increase nesting population of crusher for crushing;
4) Check the gears and pitch size, such as sub-standard replacement jaw plates are required, align the activities of the fixed jaw plate and the relative position of the jaw plate, ensuring top of the gear tooth root, the fixed compression, prevent displacement;
5) Increasing the voltage of the workplace, to adapt the host heavy requirements;
6) The replacement of bearings or a moving jaw.
Shanghai Jianye Heavy Industry staff noted that the output of the jaw crusher was not a time when compliance must consult professionals, such as purchase of machinery manufacturers, after determining the problem to solve the problem, do not blindly seek source of the problem.
