The preparation work before running of the vibrating feeder

(1)Check the note on duty and deal with problem last time.
(2)Check and debar the mill.Check out if there are sundries that can stop working between the spring and bracket.
(3)Check carefully whether allthe fasteners are firm.
(4)Check out whether the surface of the lubricating oil is higher than the height of the mark.
(5)Check out whether the conveyor belt is good.If the converyor belt is dishcloth,you should replace it.If there is smeary,youcan rub it use a dishcloth.
(6)Check out whether the protective device is all right,if there are unsafe phenomenas you should get rid of them in time.

Starting of the vibrating feeder

(1)Start after make sure machine and transmission part's condition is normal.
(2)This machine should be started unloaded.
(3)Stopped immediately when some abnormal happen and start again after getting rid of the matters you can run it again.

Using of the vibrating feeder

(1)After shaking steadily,it can run with material.
(2)Feeding materials should meet the requirement of running unloaded.
(3)Stop should be carried out along the ethnics.It forbids the machine to stop when there are materials in it.And it also forbid feed when the machine is stopped or after stopped.