The cone crusher of PYF series, widely used in the industries of metallurgy, building material, road construction, chemical engineering & silicate, is suitable for crushing all kinds of ores and rocks with hardness of medium or above. This cone crusher  features the high crushing ratio, high efficiency, high handling capacity, low operation cost, easy adjustment and economical operation. The quality of material used for components and reasonable design of construction contributes to its longer running performance and even granularity of the crushed product in addition to reducing the circulation load; and furthermore by introducing the hydraulic cleaning chamber system into the crushers of middle and large size, the down time is reduced accordingly. The user may choose different type of chamber upon different request ferrly, because of the wide range of products to be provided.

This cone crusher adopts grease sealing so as to prevent the watering and draining system from being blocked and avoid the defect of easy mix of water and oil. The spring safety system is the protection unit against overload, and keeps the crushing chamber from being damaged by foreign substance or iron pieces.

This cone crusher is divided into two types; the standard type and the short head type. Normally the large size of material is fed into the standard type, which means that the size of discharge is also much coarse; and the small size of material is fed into the short head type due to its steep crushing cone, which will unavoidably influence the size of discharge, and therefore it is much suitable for producing the fine goods. Consequentially the standard type is generally used for medium and coarse material, and the short head type for medium and fine material.

1.       The producing capacity indicated in the table largely depends on the feed size, type of crushing chamber,density of material, cleanness of material and water content.

2.       The minimum discharge opening refers to the minimum discharge opening that can be realized without causing support sleeve to jump. It is related to material, and subject to variation.

3.       The producing capacity can be attained only under the condition of open flow, and when compression strength is 140Mpa~150Mpa,the water content not more than 4%,the oversize and undersize not more or less than 10%,and the load of motor between 85%-90% of full load as well as even feeding.

4.       The height of machine includes feeding frame.

5.       The four digits in the model means :the first two are 1/100 of the diameter of the crushing cone ,and the rest are 1/10 of the size of the discharge opening on open edge.

6.       The Data is subject to variation without further notice.